Confirming The Projector Position - Epson BrightLink Solo Guide D'installation Rapide

Confirming the Projector Position

Once you have determined where to install the interactive module, you can determine whether the
projector's position needs to be adjusted to avoid possible interference.
You can mount the interactive module and then test the installation with your projector turned on. Or, you
can follow the steps below to calculate whether your projector's position needs to be adjusted.
1
Measure the following projector distances:
• The distance from top of the projection area to the top edge of the projector's lens (
• The distance from the wall to the top of the projector's lens (
Arm length is 41.73 inches (1060 mm)
2
Make sure the distance from the top of the projector lens to the top of the image (
( –5.9 inches) × /41.73 inches
b c
or ( –150 mm) × /1060 mm
b c
If the distance from the top of the projector lens to the top of the image (
value, the interactive module can be used without adjusting the projector position.
AVOID
Projector
c
11
)
a
)
) is less than:
a
) is less than the calculated
a