Dexter Laundry T-50 Manuel De L'utilisateur page 31

5) Press the UP touch pad switch 28 times until the display of the dryer controller shows the number "53".
6) Press and release the SELECT/ENTER touch pad switch of the dryer controller once. The dry cycle 5
L.E.D. and the programming L.E.D. will remain on, the dry time L.E.D. will switch off, the temperature
L.E.D. will illuminate, and the dryer controller display will show the number "175".
7) Press and release the UP touch pad switch four times until the dryer controller display shows the number
"195".
8) Press and release the SELECT/ENTER touch pad switch of the dryer controller. The dry cycle 5 L.E.D.
and the programming L.E.D. will remain on, the temperature L.E.D. will switch off, the cool down L.E.D. will
illuminate, and the dryer controller display will show the number "5".
9) Press and release the UP touch pad switch once until the dryer controller display shows the number "3".
10) Press and release the SELECT/ENTER touch pad switch of the dryer controller. The dry cycle 5 L.E.D. and
the programming L.E.D. will remain on, the cool down L.E.D. will switch off, the reversing L.E.D. will
illuminate, and the dryer controller display will show "nrEv".
11) Press and release either the UP or DOWN touch pad switch on the dryer controller once. A flashing "rEv"
will appear on the dryer controller display and the reversing L.E.D. will start to flash. Each press and
release of either the UP or DOWN touch pad switch will toggle between the reversing mode ("rEv") and
the non-reversing mode ("nrEv").
12) Press and release the SELECT/ENTER touch pad switch of the dryer controller. Once the SELECT/ENTER
touch pad switch is pressed and released, the reversing L.E.D. will switch off, the programming L.E.D. and the
dry cycle 5 L.E.D. will remain on, and the flashing "rEv" will be replaced by the word "Prog".
13) Press and release the STOP touch pad switch of the dryer controller. The dry cycle 5 L.E.D. will remain on,
the programming L.E.D. will switch off, and the dryer controller display will change to the word "LOAd".
The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 5 program will remain
in the dryer controller memory until the default settings push button is pressed. This default setting push button
is located on the component side of the dryer controller printed circuit board at the lower middle side.
8514-262-001 REV G PAGE 31