SilverCrest SED 3.7 E2 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5) Place the epilator perpendicular to the skin and, without exerting
any pressure, move it against the direction of the hair growth.
Thereby, the side with the speed switch
you. Do not make back and forth or circular movements.
Always start anew and pass over the body part to be epilated
several times, so that all of the hair is removed.
NOTICE
It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are finished with the treatment, place the speed switch
to "0".
7) Clean the epilator head
and Care".
8) Replace the protective cap
NOTICE
If the epilator head
To order a new epilator head
partment (see chapter "Guarantee and service"). Please have
the IAN number ready (see operating manual cover).
To replace the epilator head
Press the two restraint fixtures
same time pull the epilator head
Press the new epilator head
Ensure that the gears on the epilator head
the appliance mesh with each other. The epilator head
must audibly engage.
GB │ IE │ NI
12 
as described in the section "Cleaning
on the epilator head
is damaged, discontinue all further use!
, please contact the service de-
, please proceed as follows:
must face towards
.
together and at the
upwards.
onto the appliance.
and on
SED 3.7 E2

Publicité

Table des Matières

Dépannage

loading

Table des Matières