Set-Up And Connection; Use - MAXXMEE 02767 Mode D'emploi

EN

SET-UP AND CONNECTION

Please Note!
■
Check the device and the connecting
cable for damage each time before
putting it into operation. Use the
device only if it is undamaged and in
working order.
■
Never place the device on a soft
surface. The ventilation openings on
the bottom of the device must not be
covered.
■
Ensure there is suffi cient clear space
on all sides. Do not place the device
below kitchen wall units or similar
cupboards. The rising steam could
cause damage to them!
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Do not use any extension cables.
■
Do not connect the device along with
other consumers (with a high wattage)
to a multiple socket in order to pre-
vent overloading and a possible short
circuit (fi re).
■
Make sure that the connecting cable
does not present a trip hazard. It may
not hang down from the surface on
which the device is placed in order to
prevent the device from being pulled
down.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces (e.g. of the
device).
20
1. Place the device on the kitchen unit or
another dry, clean, fl at and heat-re-
sistant work surface. Ensure there is
suffi cient clear space on all sides (at
least 20 cm to the sides and 50 cm
above).
2. Fully unwind the connecting cable
and plug the mains plug into a plug
socket.

USE

In general, you can use this device to pre-
pare all dishes that can also be prepared
in a conventional fan oven. For good
results, read through the "Tips" chapter.
Please Note!
■
Before using the device, make sure
that the device and the outsides of
the drawers are clean and dry.
■
Do not use the device for longer than
4 hours without a break. An exception
is the DEHYDRATE programme.
■
Do not leave the device switched on
when it is empty (apart from "burning
off" prior to fi rst use).
■
Do not place food that is still wrapped
in cling fi lm or plastic bags into the
device.
■
Make sure that the food does not
come into contact with the heating
elements.
■
Do not overfi ll the drawers so that the
hot air can circulate optimally inside
the cooking chamber. Fill it no more
than 1/3 full.
■
Make sure that foodstuffs containing
oil and fats are not overheated. They
could ignite.
■
Always place the hot drawers down
on a heat-resistant surface after use.
 
Preheating of the device is not
necessary.