Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MOUNTING OF THE BIKE CARRIER ON THE CAR
The first step is to become familiar with the quick connector.
Plastic locking device
Green mark
Lock
Quick connector handle
Quick connector adjustment screw
The quick connector consists of a case mounted to the
bike carrier and a lever. Using the lever, you can close and
open the quick connector. Using the sliding locking devise
to lock the handle of the quick connector and finally lock
the complete quick connector with the key (mandatory
during use!).
When mounting the bike carrier to the car, it is best that
the car is parked straight, the engine is turned off and the
parking brake is activated. Make sure that the tow ball is
undamaged, clean and not greasy!
Open the lock of the plastic locking device with use of the supplied key. Turn the
key one quarter (key stands now
vertical). Slide the plastic locking
device to the right (only open red
lock is visible on the handle).
Release the quick connector by
moving the handle in the vertical position.
Position the bike carrier on the tow-bal from the top. Press the handle of the
quick connector downwards (approx. 35-40kg) until it stops (handle will stay
stable in the horizontal position).
Slide the plastic locking devise to the
left until the green mark on the
handle is 100% visible.
36
Publicité
Table des Matières
