Gaggenau VG 232 220 CA Notice De Montage page 12

en-us
Conversion to another type of gas
Replacing the main control nozzles:
1.
Remove the pan support and all burner parts.
2.
Undo the fastening screws on the burners (two screws
on each burner). Lift the burners upwards and remove
them.
3.
Undo the earthing screw on the rear burner. Carefully
lift the hob upwards and remove it.
4.
Remove the control knob.
12
5.
Undo the fastening screws on the control panel.
Remove the control panel and disconnect the
connection cable on the back of the control panel.
6.
Replace the nozzles. You can obtain a key from our
customer service (order number 00424699). Take care
not to break the nozzles when (un)screwing them.
7.
Screw the new nozzles in as far as possible to obtain
a tight seal.