Ryobi RLT3725CH-A Manuel D'utilisation page 21

GB
F E
Problem
Line will not advance when
tap bump button
Bump head is hard to turn
Grass wraps around the
attachment shaft and the
trimmer head assembly
Waste electrical products should not be disposed of together with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for recycling advice.
I P NL S
TROUBLESHOOTING
Possible cause
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up
around head.
Cutting tall grass
at ground level.
DK N FIN
English
Solution
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while alternately pressing down on and
releasing bump button.
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
DISPOSAL
15
GR TR EST LT LV