Progress PDG6140E Mode D'emploi Et Installation page 43

EN
HOOD BODY MOUNTING
• Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
• Hook the hood body onto the screws 12a.
• Fully tighten the support screws 12a.
• Adjust the screws Vr to level the hood body.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the
hood to the chimney using either a fl exible or rigid
pipe ø 150 or 120mm, the choice of which is left
to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer fl ange 9 on the hood body
outlet.
Fix the pipe in position using suffi cient pipe
clamps (not supplied).
• Remove possible charcoal fi lters.
RECIRCULATION VERSION AIR OUTLET
• Insert the connection extension pieces laterally
14.1 in connec-tion 15.
• Insert the Connector 15 into the Support bracket
7.3 and fi x it with a screw.
• Make sure that the outlet of the extension pieces
14.1 is hori-zontally and vertically aligned with
the chimney outlets.
• Connect the air outlet connection 15 to the hood
body outlet using either a fl exible or rigid pipe
ø 150 mm, the choice of which is left to the
installer.
• Ensure that the activated charcoal fi lters have
been inserted.
progress
12a
ø 150
9
7.3
15
ø 150
43
Vr
ø 120
14.1