Samsung harman/kardon HW-Q90R Manuel D'utilisation page 32


Sound Control

WOOFER

VOL
You can select TREBLE, BASS, SYNC, CENTER LEVEL, SIDE LEVEL, FRONT TOP LEVEL,
REAR LEVEL, REAR TOP LEVEL, and VIRTUAL ON/OFF.
– To control the volume of the treble or bass sound, select TREBLE or BASS in Sound
Settings, and then adjust the volume between -6~+6 by using the Up/Down buttons.
– Press and hold the
for each frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are
selectable using the Left/Right buttons and each can be adjusted to a setting
between -6 to +6 using the Up/Down buttons.
– To control the volume of the each speaker select CENTER LEVEL, SIDE LEVEL or
FRONT TOP LEVEL in Sound Settings, and then adjust the volume between -6~+6 by
using the Up/Down buttons.
– If the video on the TV and audio from the Soundbar are not synchronised, select SYNC
in Sound Control, and then set the audio delay between 0~300 milliseconds by using
the Up/Down buttons.
– If Surround Speakers are connected, select REAR LEVEL or REAR TOP LEVEL, and
then use the Up/Down buttons to adjust the volume within a -6 to +6 range.
The VIRTUAL Speaker function can be turned ON/OFF by using the Up/Down
buttons.
– SYNC is only supported for some functions.
• Initialise
With the Soundbar turned off, press and hold the
than 5 seconds until the speaker turns on. "INIT" appears on the display and the
Soundbar is initialised.
Push the button up or down to adjust the volume of the subwoofer to -12 or between -6 to
+6. To set the subwoofer volume level to 0, press the button.
Push the button up or down to adjust the volume.
• Mute
Press the VOL button to mute the sound. Press it again to unmute the sound.
(Sound Control) button for about 5 seconds to adjust the sound
ENG - 28
(Sound Control) button for more