Cleaning And Maintenance - Fagor SP-1200 Manuel D'utilisation

interior.qxd 9/9/03 17:06
respected in the use of any electric
appliance.
IN PARTICULAR
• Do not touch the appliance with wet or
damp hands.
• Do not use the appliance barefoot, or
when your feet are damp or wet.
• Do not use the appliance when your
body is wet. Dry yourself before use.
• Do not submerge the appliance in
water or let it become splashed.
• Do not use the appliance
in the bath or shower, in
damp areas or near
liquids (over a hand basin
full of water, for
example).
• For greater protection, we recommend
that you install a residual current
device (RCD) with a maximum current
of 30 mA in the electrical circuit of
your bathroom. Consult your
electrician for more details.
• Never pull on the cable to unplug the
appliance.
• Do not leave the appliance open to the
elements (rain, sun, frost, etc. ).
• Do not allow children or the mentally
disabled to use the appliance without
supervision.
• Do not leave the appliance on
unnecessarily, as this may constitute a
health hazard. Unplug the appliance
when not in use.
• Keep the air inlet and outlets clean and
unobstructed. If the air inlet or outlet
becomes blocked, the appliance will
switch off automatically. If this occurs,
leave to cool for a few minutes, unblock
the inlet/outlet and use as normal.
• Always unplug the appliance before
carrying out any cleaning or
maintenance operations.
Página 5
On-Off switch
0 = Off
1 = Gentle flow/warm air
2 = Strong flow/hot air
Important: This model has two voltage
settings: 120V~ and 230V~.
Before using the appliance, make sure that
the selected voltage setting coincides with
the mains voltage in your home. Failure to
do this may result in irreparable damage to
your appliance.

5. CLEANING AND MAINTENANCE

Clean the outside of your appliance with a
dry cloth
Keep the air inlet and outlet grilles
unblocked. Clean with a dry brush to
remove accumulated hair and fluff.
Never submerge the appliance in water
or any other liquid.
The manufacturer reserves the right to
modify the models described in this User's
Manual.
6
4. WORKING