Fellowes POWERSHRED 225Ci Instructions D'utilisation page 2

A.
B.
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper, credit cards, CD/DVD, staples, small paper clips and junk mail
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, large paper clips, folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut (225Ci) .........................................................................................4mm x 38mm
Strip Cut (225i) ...................................................................................................... 5.8mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
set to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
2
G.
H.
KEY
A. SafeSense Technology
I. ®
B. Paper/card entry
C. CD entry
D. Door
E. Basket
F. Casters (4)
Maximum:
Sheets per pass, 80g paper (Cross-cut) ......................................................................... 20*
Sheets per pass, 70g paper (Cross-cut) ......................................................................... 22*
Sheets per pass, 80g paper (Strip-cut) .......................................................................... 20*
Sheets per pass, 70g paper (Strip-cut) .......................................................................... 22*
CDs/Cards per pass ....................................................................................................... 1*
Paper entry width .................................................................................................. 240mm
* A4 paper at 220-240V, 50/60 Hz, 3Amps; heavier paper, humidity or other than rated voltage may
reduce capacity. Maximum recommended daily usage rates: 5,000 sheets; 200 cards; 10 CDs.
Fellowes SafeSense
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
) to back out object.
G. Disconnect power switch I. Control Panel and LEDs
1. OFF
2. ON
H. See safety instructions
® shredders are designed to be operated in office environments ranging
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket
transformers, or extension cords should not be used with this product.
ENGLISH
Models 225Ci/225i
1. Reverse
2. ON/OFF
3. Forward
4. Auto
5. Door open (red)
6. Bin full (red)
7. Remove paper (red)
8. SafeSense indicator (yellow)
®