Pump Priming - Acqua Brevetti MiniDue Filtro PM006 Manuel D'instructions

B1.5 Hydraulic checks after installation
After opening the water upstream of the equipment check for leaks;
Check for the correct installation of the pump in order to facilitate ordinary maintenance operations.
1) Verify the presence of a by-pass circuit that permits the exclusion of the pump and the
presence of sampling faucets upstream and downstream of the pump.
2) Check the correspondence of the system to any rules or recommendations issued by the
competent local area offices.
3) Check periodically that AcquaSIL 2/15
the refill bag has to decrease proportionally with water treated). If this is not the case, please
contact Acqua Brevetti Srl (telephone: +39.(0)49.8973432 e-mail info@acquabrevetti.it).
B1.6 Allowed installation schemes
Install MiniDUE FILTRO according to the following scheme. Any other configuration may lead to the
non proper working of the device. Do not over close the connections.
In case of doubt please contact Acqua Brevetti Srl (Tel.: +39.(0)49.8973432 or send an e-mail
info@acquabrevetti.it).

PUMP PRIMING

To ensure correct priming of the pump proceed as follows:
a) MiniDUE FILTRO pumps - refill bag directly connected to the pump: before attaching the bag,
press it until a few drops of product come out. Insert the refill bag.
b) MiniDUE FILTRO pumps – bag remote connection: squeeze the refill bag carefully in order
to speed up the priming phase of the product in the plastic pipe of the pump.
MiniDUE FILTRO - ENGLISH
®
is regularly consumed (the amount of product inside
PM006
Exit
MAN 117 PAG.E-10
Entry
To drain