Erreka ULS45EC Guide Rapide D'installation Et Programmation page 14

1 Connect the
supply and close the barrier by
keeping PUL1 pressed down.
4 Press the button for the required
channel. DL2 flashes to show
programming is complete.
I
II
1 Connect the electrical power supply
and close the barrier by keeping
PUL1 pressed down.
4 Wait for it to come to a stop at the
end of its travel.
7 Place DIP1 and DIP2 in OFF. DL3
remains off.
14
SW2 functions during programming (DIP1 = ON)
E289L
Radio code programming (only with RSD receiver)

If a receiver other than RSD is used, see the corresponding instructions.
electrical power 2 Select the code in the transmitter.
R289A
5 Place DIP1 and DIP4 in OFF.
R289D
Open/close programming
2 Place the DIPs as shown in the
figure (DIP2=ON, DIP1=ON).
DL3
programming mode enabled.
R289A
5 Press ST1 to start closing.
G289C
DIP1=ON: programming enabled (DL3 lights up)
DIP1=ON and DIP2=ON: open/close programming
DIP1=ON and DIP4=ON: radio code programming
R289C
DL3 remains off.
R289E
lights up to
G289Z
G289D
R289E
3 Place the DIPs as shown in the
figure (DIP1=ON, DIP4=ON). DL3
lights up to show programming
mode enabled.
6 Disconnect and reconnect the
electrical power supply.
3 Press ST1 to start opening.
show
6 Wait for it to come to a stop at the
end of its travel.
The barrier is supplied with
open/close settings
programmed at factory.
R289B
G289A
G289F