EN
Maintenance
Dust bin, motor unit and filters
Dust bin
Empty the dust bin after each use.
Check that the vacuum is turned off and unplugged. Open the dust
bin cover to empty it quickly and easily (see dust bin diagram on
page 5)
NOTE: Take care when opening the cover as the dust could fall out on to the floor.
Motor unit and filters
To clean the motor unit and filters, press on the release button to
remove the dust bin (see the motor unit diagram on page 5).
Lift off the protection filter and unlatch the HEPA filter (see the
Filters diagram on page 6). Remove the second protection filter that
surrounds the HEPA filter, then shake them outdoors to remove the
built-up dust particles. Clean the two protection filters with clean
water.
Then pull out the cyclone system and clean it with a soft cloth to
remove all of the dust.
NOTES:
•
Make sure the protection filters are dry before you put them back in the dust
bin.
•
The HEPA filter cannot be cleaned, otherwise it would become damaged. If the
HEPA filter is damaged, you are recommended to replace it to ensure that your
vacuum's filter performance is maintained.
12