Renishaw TS20 Guide D'installation Et D'utilisation page 18

1-8
Stylus alignment
in X and Z axes
Alignment of the stylus with
the machine X and Z axes is
obtained by slackening the
four M3 x 8 mm clamping
screws and rotating the
probe body.
When alignment is achieved,
tighten the clamping screws.
TS20 PROBE with SIGNAL CONDITIONING MODULE
dimensions mm (in)
Clamping
screws
0,5 x 45°
(0.02 x 45°)
Signal conditioning module
2950 (116)
32 (1.26)
Ø8 (Ø0.32)
3
(0.12)
1,6 (0.063)
1,5 (0.059)
R 0,5 MAX
(R 0.02 MAX)
47 (1.85)
Ø15 (0.59)
MINIMUM clearance
'O' ring supplied may be fitted in
groove to seal probe mounting
Recommended 'O' ring dimensions
Ø1 x 18,1 ID (Ø0.039 x 0.71 ID)
1,6µm
(63µin)
32 (1.26)