Kampa Travel Pod Action AIR Guide De L'utilisateur page 3

Before using for the first time please check the contents of your awning.
Awning
Lateral AirPole (Action/Motion only)
Aluminium Canopy Pole (Action/Motion only)
Toggle-in Groundsheet
Hand Pump
Peg Bag
If you are missing any parts please contact your supplying dealer.
Attachment to Vehicle
The Travel Pod has a tunnel at the rear that can be attached to a vehicle, like
the side door of a camper van (VW style).
Keder Beading
The tunnel has Keder beading sewn to its top edge. The beading can
be threaded into 'figure-of-8' extrusion (not supplied) and the figure-of-8
clipped to the gutter on the side of the vehicle. Kampa figure-of-8 extrusion
is available from your supplying dealer.
Guy Line/Rope
If your camper does not have a gutter it is possible to pull the tunnel to
the vehicle by attaching guy lines/ropes (not supplied) to the top corners
of the tunnel, throwing these over the vehicle and tying them to the wheels
or pegging them down. Take care that the guy lines/ropes do not damage
the vehicle.
Velcro Straps
If your vehicle has roof bars installed, the velcro straps, attached to the pole
sleeve, can be fixed around them.
Pole & Clamp Fixing (Optional parts required)
This requires an optional pole and clamp set available from your dealer.
The pole is threaded through the sleeve in the top of the tunnel. This is then
dropped into the gutter on the side of the camper and secured using the
clamps provided.
Using Your Roll Out Awning (If fitted)
The Keder beading can be slid into the channel found on the front of most
roll out awnings. It may be necessary to use a Drive-Away kit to convert the
size of the beading. Your dealer will be able to offer more advice.
3
1
1
1
1
1
1
TP-AIR-UM-09-17-Rev.B