aqua SALT Manuel D'instructions page 79

AQUA SALT
Salt chlorine generator
The pH Probe Calibration Menu calibrates the pH probe in case the model supports it. Calibration regulates
4.5.5
the measurement tool and improves its efficiency. Calibration may have one or two reference points. pH
pH probe
probe calibration must be done as follows:
calibration
1) Rinse the probe in a bottle of drinking water
menu 2) Dip the pH probe in the buffer solution (pH 7), slowly move for 3 seconds and press Enter.
3) Wait without touching the probe or its cable for at least 60 seconds, until the value read is
stabilized, then press Enter.
4) At the end of the countdown or after pressing Enter, the pH value of the solution (7.00) and the
value read by the probe (in mV) will be shown.
5) For a calibration with one reference point, press F and move to point 8. Otherwise, rinse the probe
in the drinking water bottle and dip it in the pH 4.01 solution. Slowly stir for 3 seconds, then press
Enter.
6) Wait without touching the probe or its cable for at least 60 seconds, until the value read is
stabilized, then press Enter.
7) At the end of the countdown or after pressing Enter, the pH value of the solution
value read by the probe (in mV) will be shown.
8) The procedure ends visualizing the quality of the probe with a percentage from 0 to 100. If quality
is below 25%, we recommend to replace the probe.
9) Place the probe back in the probe holder or on the piping of the filtration system.

Press Enter to move through the calibration steps.

Press and hold Enter for about 1 second to go back to the pH Calibration section of the Installer
Menu.
The Programming menu sets the parameters to programme and manage the operation of your chlorine
4.5.6
generator.
Programming


Menu
ADSP7000648
Probe
Quality
pH 4.01
Waiting
Press F to scroll the menu sections
Press and hold Enter for 1 second to go back to the Programming section of the Installer Menu.
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
Dip the
probe in
the water
Waiting
Installer Menu,
pH calibration
pH 7.00
Rinse the
probe
31/07/2017
ENGLISH
and the
(4.01)
79
79/264