Connection To The Mains - FrostEmily PEGASO Mode D'emploi

7.

CONNECTION TO THE MAINS

1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
I
to the appliance.
earthed. b) It fulfils the requirements of the rated current as set out on the rating plate.
UK
the IEC regulations: - magnetothermal differential switch with In = nominal value as stated on the rating
plate; - Differential with Id sensitivity = 30 mA.
D 4.
room. The connecting cable to the appliance is H05 VVF, designed for internal use.
transport or storage the appliance has been placed by mistake in a horizontal position or has been turned
upside down, leave for at least three hours in the correct position before switching on the power supply.
E
Connect the plug (do not use three-way adapters and reduction adapters) (see figure3).
F
CONTROLS
8.
The appliance features adjusting controls, protected on the front side.
NL
switch on the refrigeration unit.
Thermostat:
P
temperature set-point, which can be changed by press button
S
CHECKING CORRECT OPERATION
9.
Check that: 1.
is ON. 3. The thermometer shows the desired temperature for the goods to be stored.
DK
not exposed to direct sunlight or high-powered lamps.
which the appliance is designed to work normally, i.e. +25°C, R.H.60% (climatic class 3).
FIN
that there are no direct air currents from doors, windows, ventilators or air conditioner pipes, inside the
appliance itself.
B
GR
CZ
Our products are for internal use only do not install outside restaurants, shops.
EE
LV
LT
H
M
PL
SK
SLO
2. Ensure that the supply socket has the following characteristics: a)
2. Thermometer:
to adjust the temperature in the appliance.
the appliance is plugged in.
Operator's guide
3. Ensure that there is no danger of explosion (AD) in the
to display the temperature in the appliance.
a) Press button
4 "UP"
2. The refrigeration unit is switched on and that the green light
5. The room temperature does not exceed that in
6
it is properly
c) It complies with
N.B.
If during
1. Refrigeration unit switch:
3 "SET or P" once to display the
or button 5 "DOWN" (see figure 2).
4. The appliance is
6. Make sure
5.
to