Sony BETACAM SX DNW-A28P Instructions D'opération page 59

5-2-3 Creating a Virtual Shot
Mark
During playback or search, press and hold the SHIFT
button, and press the MARK/UP button while holding
the SHIFT button.
A virtual shot mark is entered, and the message "V-
MARK xxx" appears on the monitor and in the lower
part of the FL display panel (xxx is the mark number).
5-2-4 Displaying Shot Mark List
To display the shot mark list, press and hold the
SHIFT button, and press the LIST/DOWN button
while holding the SHIFT button.
Press the buttons again to cancel the display.
The figure below shows the contents of the shot
marker list.
SHOT MARK
(003/180)
NO. TIME CODE
1. #R 10:02:35:01
2. S1 10:04:05:20
*3. #S2 10:05:35:12
4. #V 10:07:05:11
Mark type: R (REC Start), S1(Shot
Mark 1), S2 (Shot Mark 2), V (Virtual
Shot Mark), P (Post Mark)
Memo mark
Selection mark: Shows the cue up shot
mark.
To view a help screen, you can press the MENU
button with the shot mark list displayed.
The help screen explains which buttons to use in the
following operations.
To select a mark
Rotate the jog dial to move the selection mark ( * ) to
the left of the number of the mark you want to select.
To attach a memo mark (#)
Select the mark to which you want to attach the memo
mark, then press the SET button.
Detaching the memo mark
Select the mark from which you want to detach the
memo mark, then press the SET button.
To make the shot mark list of selected
shot marks
1
Display the shot mark list and press and hold the
STOP button, and press the SET button while
holding the STOP button.
The mark selection display appears.
Current cursor
2
Rotate the jog dial to select a mark.
position number/
total number of
marks memorized
3
Rotate the jog dial while holding down the
Timecode
SEARCH button to select ON or OFF for the
selected mark. Select ON to list it and select OFF
to skip it.
Returning to the shot mark list display
Press the STOP button together with the SET button.
Chapter 5 Shot Mark/Shot Data
5-5