Promax GV-998 Manuel D'utilisation page 80

If you wish to store the new configuration, from any of the configuration menus,
select the STORE field (appearing shadowed), press the rotary selector to activate it
(appearing underlined), turn it to select the memory number according to the format
STOXX (XX from 00 to 31), and finally press the rotary selector until you hear the
signal (the current state of all the parameters on the three configuration menus will then
be stored in the chosen memory).
The different parameters which may be modified in each of the configuration
menus is described next.
4.2.2.1 ANALOG configuration menu
Q
P
O
N
M
L
K
Figure 5.- Example of the ANALOG configuration menu display
[A] Memory
Shows the active memory position. At start up the initial position is 00. To activate
a different memory, select this field (seen shadowed in figure 5) and activate it by
pressing the rotary selector. Then, by turning it, it will be possible to load one of
the stored memories (from position 00 to 31). This field appears in all the
configuration menus.
[B] STORE
Allows storing the parameters active in the three configuration screens onto a
memory position. To do this, after selecting the STORE field (appearing
shadowed), press the rotary selector to activate it (appears underlined), turn to
select the memory number according to the STOXX format (XX from 00 to 31),
and finally press the rotary selector again until you hear the confirmation signal
(the current state of all the parameters of the three configuration menus will then
be stored in the chosen memory). This field appears in all the configuration
menus.
Page 26
A R
J
Colour pattern generator GV-998
B
C
D
E
F
G
H
I
12/2004