Connection; Concluding Tasks - Calira C3 Mode D'emploi

% &
! " #

Connection

% # &
$
Connection on Module B
Make sure that all power cables from battery and mains of Module A and B are
switched off or separated. See operating instructions of Module A and B.
Remove the terminal area covers from Module B. See operating instruction for
Module B.
Connect the 4-pole plug of the serial RS 485 data transmission cable to the
connection of Module B. See operating instruction for Module B connection
diagram (fig. 3 pos. 6).
Connect the serial data cable RS485 to the 4-pole connection on Module C3. A
main switch is integrated onto Module C3. Should there be a separate main
switch already connected on Module B, this will be functionless through the
connection of a Module C3 and can be removed.

Concluding tasks

Check that all the cables are firm and secure. Put on the terminal area cover.
Connect the mains as the final step.
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49 (0)8341 9764-0 Fax: +49 (0)8341 67806
! $
$ " $
"
15