Installation And Connection - Oase FiltoSmart 100 Notice D'emploi

6. Fit the holder and fasten it onto the separating plate
(FiltoSmart 200/300) or to the wall of the container
(FiltoSmart 100).
7. Push the heater into the holding ring as far as it
goes.
– To facilitate installation, moisten the glass bulb of
the heater with water.
– Do not fit the heater until all work has been com-
pleted. (→ Fitting the unit head)
– Ensure that the O ring is correctly positioned.

INSTALLATION AND CONNECTION

Order of tasks to be carried out:
1. If the unit is to be installed in a standing position: Fit
the enclosed rubber feet onto the base of the con-
tainer.
2. Retrofit the heater unit if necessary (→ Fitting the
retrofit set)
3. Position the filter media (→ Cleaning/replacing the
filter media)
4. Install the unit.
– Install the unit next to or under the aquarium.
Note the maximum head height. (→ Technical
data)
5. Establish the connections (→ Establishing the con-
nections)
Ensure adequate stability
 J
To increase stability, the container is fitted in a stand
(removable).
• Screw the enclosed rubber feet into the stand.
• Only install the container with the stand fitted.
Establishing the connections
Assembling the suction unit
How to proceed:
 L
• Assemble the suction unit.
• Set the flow rate.
– Use a coin to turn the flow regulator in the hose
adapter in the direction of MIN or MAX.
Assembling the flow-out unit
How to proceed:
 M
• Assemble the flow-out unit.
– The water distributor can be used instead of the
flow-out pipe.
• Use a coin to turn the flow regulator in the hose
adapter to MAX.
Connecting the hose
The procedure is identical for the inlet (IN) and outlet
(OUT).
How to proceed:
 N
1. Shorten the hose to the required length.
– Chose the length so that the hose cannot kink in
the intended installation position.
2. Screw the union nut onto the hose connector of the
connection unit.
3. Push the hose onto the hose connector and turn the
union nut counter-clockwise to fix the hose in place.
4. Push the other end of the hose onto the hose con-
nector at the suction unit/flow-out unit and turn the
union nut counter-clockwise to fix the hose in place.
 C
• Fasten the suction unit and flow-out unit in the
aquarium using suction cups.
COMMISSIONING/START-UP
N O T E
Thoroughly rinse out all filter material with warm tap
water before using for the first time in order to remove
any soiling. (→ Cleaning/replacing the filter media)
N O T E
Ensure that the pump never runs dry!
The pump will be destroyed.
• Regularly check the water level and circulation in
the filter and in the aquarium.
- EN -
21