Hydro-Pro+ INVERBOOST+ Tec 7018545 Notice D'installation Et D'utilisation page 25

Hold and
Water temperature setting :
or
Press
Parameter checking :
Press first, then press
Code
d0
d1
d2
d3
d4
d5
d6
d7
d8
d9
d10
d11
Press first, then press
Code Name
P1 Working mode
P2 Timer on/off
P3 Water pump
P4 Current time
P5 Timer on
P6 Timer off
Inlet water temp.
P7
correction
6.2.4 System reset function
Press and
6.2.5
for 5 seconds to lock/Unlock the display.
to set the water temperature directly.
to check the " User parameter from d0 to d11
Condition
IPM mould temperature
Inlet water temp.
Outlet water temp.
Ambient temp.
Return gas temp.
Piping temp.
Gas exhaust temperature
Step of EEV
Compressor running frequency
Compressor current
Current fan speed
Error code for last time
to check/adjust the " User parameter from P1 to P7
Scope Default
0-1 1
0-1 0
0-1 0
HH:MM
00：00
HH:MM 00：00
HH:MM 00：00
-9～9 0
in 10s, the system will reset and display "0000" on the controller.
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
-30℃～70℃
-30℃～70℃
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 （rpm）
All error code
1 Heating mode，0 cooling mode
1 Timer on/off is under function ， 0 Timer on/off is out of
function (The setting of P4 and P5 won't work)
1 Always running，0 Depends on the running of compressor
0-23:0-59
0-23:0-59
0-23:0-59
Default setting: 0
- 23 -
Remark
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
N*5
Real testing value
Real testing value
Real testing value
Remard