Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
a. IN THE EXTRACTION MODE:
Place the anti-backflow flats item 9 over the round outlet ,
the telescopic duct and connect the ducting 150mm (6 INS)
over the round outlet on top of the canopy and secure the
connections withappropriate clamping rings or adhesive
tape ( Fig. 3).
IN THE RECIRCULATION MODE:
Fit the recirculation spigot 15 onto the upper chimney wall
bracket using the same fixing screws (Fig. 1 item 7.1).
Connect the ducting 150mm (6 INS) not provided between
motor and the recirculation spigot item 15 and secure the
connections with appropriate clamping rings or adhesive
tape (Fig. 3)..
b. Remove the grease filters (see paragraph Maintenance)
Fig. 4 being sure that the connector of the mains cable is
correctly inserted in the socket placed on the sides of the fan.
Before fitting the chimney to the canopy make the electrical
connection as described in the section titled ELECTRICAL.
When the electrical connection has been made, test the
lights and the fan motor.
c. IN THE RECIRCULATION MODE: Insert the charcoal filter
into the base of the motor housing and secure the filter with
two metal securing straps item A as illustrated in Fig. 5.
d. Each chimney stack consists of two sections. Fit the upper sections
(Fig. 6 - item 2.1 & 2.2) first by expanding the chimneys slightly to
allow them to clamp around the bracket item 7.1 and secure the
slightly to allow them from the top of the canopy to clamp around the
chimney stacks to the brackets using the two M4 screws item 12c
upper chimney sections.
provided. Fit the lower chimney sections by expanding the chimneys
e. Fit the 3 front cover Item 3 - Fig 10.
f. IN THE REMOTE MOTOR MODE AND WITHOUT CHIMNEY:
Note: The Fig. 7 & 8 correspond to the versions without Motor and without chimney (SMC or WMC).
GB
Fig. 5
A
9
Fig. 3
Fig. 4
12c
2.1
2.2
Fig. 6
2 7
Publicité
Table des Matières
