Assembling The Powercel Charger - ab Naida CI Q90 Mode D'emploi

Do not connect the Zn-Air Battery Pak to the charger. The charger is
WARNING:
to be used with the rechargeable Lithium Ion PowerCels only. All four sizes of Lithium
Ion PowerCels can be used on the PowerCel Charger.

Assembling the PowerCel Charger

Power supplies and battery chargers should be operated in an open area to
WARNING:
ensure adequate airflow. While, to date, no injuries have been reported, during normal
use in the event of a fault, components may become hot. If the device's temperature
results in discomfort or pain when touched, disconnect the power source and contact AB.
Only use the charger provided for charging AB PowerCels. Do not use it
CAUTION:
to charge other batteries. Do not try to charge Naída CI PowerCels using a charger
other than that provided by Advanced Bionics.
Battery Charger
USB
The charging system consists of the charger, power supply, and power supply adapters. The
charger can also be used with the power supply removed from the cable, exposing the USB jack
so it can be powered from any USB port.
Charging Information for Lithium Ion Batteries:
The charger provided with the sound processor is designed to charge up to four PowerCels
simultaneously. It takes approximately 2-3 hours to fully charge a depleted PowerCel. This will
vary slightly for different PowerCel types.
44
Naída CI Q90 Sound Processor User Guide
Power Supply
Power Supply Adapters