Adjusting Headpiece Magnet Strength - ab Naida CI Q90 Mode D'emploi

to connect it to the headpiece. Inspect the cable on a regular basis to ensure it is in good
condition. If it appears damaged, replace it with a new cable.
To attach the cable to the headpiece:
Hold the headpiece in one hand and the
cable connector in the other hand.
To attach the cable to the sound processor:
Hold the sound processor in one hand and
the cable connector in the other hand.
For assistance in troubleshooting headpiece cables, please refer to the
of the User Guide.

Adjusting Headpiece Magnet Strength

It is important to have the correct magnet strength so the recipient does not experience
discomfort or retention issues. If an insufficient number of magnets are used in the headpiece,
it may fall off more often than is acceptable. If too many magnets are used , the recipient may
experience irritation or discomfort. Consult a hearing care professional if you have any concerns
regarding magnet strength. If deemed appropriate, your hearing care professional may insert
additional magnets or remove magnets from the headpiece. If the recipient experiences any
redness, irritation, or discomfort, discontinue use of the headpiece immediately and contact
a cochlear implant center. See the
1
1
Headpiece Instructions for Use
Push the cable connector firmly into the
headpiece connector.
Push the cable connector firmly into the
sound processor connector port.
Troubleshooting
for additional information
Naída CI Q90 Sound Processor User Guide
2
2
section
29