Virutex FR277R Mode D'emploi page 10

Always disconnect the plug from power
source before making any adjustments
or changing any accessory.
Carry our fine depth adjustment if necessary. Having
set the rough depth adjustment you can set the desired
depth to 0.1 mm accurately by turning the knob of the
adjusting bit (1 line = 0.1 mm).
First release the lever 24 (Fig. 5). While you are pushing
the tool down, press the upper button of the adjusting
bit in the direction G (Fig. 6), so that it is laid on the
screw on the revorverskem nastavku 16 (Fig. 6). Adjust
the lower button with the upper one, then turn the
upper button in the direction H for a desired value. Pull
again the lever 24 (Fig. 5)
16. FINE DEPTH ADJUSTMENT WITH
THE ROUTER FIXED IN A TABLE
Support the adjusting bit 10 (Fig. 6) on the screw of the
chip deflector by a hollow screw and a spring.
Fasten the hollow screw 14 (Fig. 6) to the adjusting bit
10. Pay attention to put the screwdriver in the inside
of the adjusting bit into the groove of the screw below
the nut 14. Pushing the cover of the tool you set the
approximate depth of cut and fasten the screw 11 (Fig.
6). Fine depth adjustment is carried out by turning the
upper lever in the direction H (Fig. 6).
Check the accuracy by a practical test or correct it
correspondingly.
17. WORK WITH THE ROUTER
Always check that the supply voltage
is the same as the voltage indicated on
the nameplate.
Switch on/off.
Switch on: Press the lock-off button 8 (Fig. 8), and then
press the switch lever 9 (Fig. 8).
Continuous operation: When the tool is switched on,
push further button 8 and lock-off the switch. Press
button 8 and lever 9 to the end, then first release the
lever 9 and the then button 8.
Switch off: Pressing again the switch lever 9 you switch
off the tool.
18. FULL WAVE VARIABLE SPEED (TYPE FR278R)
Adjusting button 5 (Fig. 1) enables variable speed from
6000 to 27000 rpm.
Constant electronics
• Enables milling of all sorts of wood, laminates, plastics
and aluminium.
10
• Enables constant set number of revolutions at heavy
loads.
• Enables setting optimal working revolutions.
• Prolongs the service lives of routers.
• Soft start of the tool and overload protection.
• Enables corresponding adjustment and greater safety
when milling with rezkarji of large diameters.
Recommended table for choosing the number of revolu-
tions regarding the worked material and bit's diameter
Symbols of materials
Gypsum boards
Aluminium
Plastics
Panel
Softwood
Hardwood
Find out the corresponding number of revolutions by
a practical test.
19. USING PARALLEL GUIDE
Fix the parallel guide 20 (FIg. 7) by inserting the adjusting
bits in the holes in the base plate 3 (Fig. 7). and fasten
them to the desired depth by two wing screws 2 (Fig. 7).
Use knob 18 (Fig. 7) for more accurate depth adjustment
by fixing the two wing screws 17 and loosening wing
screws 19. Turning the button 18 you are moving the
bit away or close to the guide. When you fully turn the