Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6 – Cleaning
• Clean all parts immediately after
use. It will not be possible to remove
residual substances when they have
hardened.
Dismantling the stirrer and stirrer axle
Driven moving parts.
Risk of injury if switched on
unintentionally.
Disconnect the device from
the power supply.
Figure 5|9: Dismantling the stirrer.
Figure 5|10: Dismantling the stirrer axle.
Cleaning the stirrer and stirrer axle
After mixing water-soluble substances
Clean the stirrer and stirrer axle under
running water. Allow the parts to dry.
After mixing substances that are not
water-soluble
Clean the stirrer and stirrer axle according
to the instructions from the substance
manufacturer. Allow the parts to dry.
Cleaning the housing
Clean the housing of the device with
a damp cloth. Do not use aggressive
chemicals or scouring agents. Blow
the ventilation slots clean using
compressed air.
50
5451920-Ruehrwerk_man.indd 50
7 – Storage
Store all parts in a clean, dry place.
8 – Repairs
Have repairs carried out by authorised
specialists only.
Do not carry out repairs on your own.
9 – Disposal
After the device has come to the end of
its service life: Ensure that the device is
disposed of in an environmentally friendly
manner for recycling.
Dispose of the device
according to regional
regulations.
Do not put it into the
household waste.
10 – Service notes
• Store the machine, operating
instructions and where necessary the
accessories in the original packaging.
In this way you will always have all the
information and parts ready to hand.
• Meister devices are to a large extent
maintenancefree, a damp cloth being
sufficient to clean the casing. Please
note additional hints given in the
operating instructions.
• Meister devices are subject to stringent
quality control. If however a functional
fault shoult occur, send the device to
our servicing address. The repairs will
be carried out in a short time.
17.10.19 09:46
Publicité
Chapitres
Table des Matières
