General Instructions; Mounting Bracket - SIGNIFY ALKCO Manuel D'installation Et Securite

CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT MUST
BE PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
UNOCCUPIED
SPACE
OCCUPIED
7ft
SPACE
Mounting Requirements:
Distance from Floor: 8' - 3" minimum
Luminaire must be perfectly level left to right
Remove the two screws from the sides of the fixture, one per side.
FIGURE 1
CAUTION: Electrical luminaires are designed for permanent installation in ordinary (non-hazardous) locations in accordance with the National Electrical
Code and all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and luminaire operate at high
temperatures, contact with combustible materials can cause fire and personal contact can cause severe burns.
© 2021 Signify Holding. All rights reserved. This document may be subject to change. No
representation or warranty as to the accuracy or completeness of the information
included herein is given and any liability for any action in reliance thereon is disclaimed.
All trademarks are owned by signify holding or their respective owners.

GENERAL INSTRUCTIONS

Ceiling
LUMINAIRE
Min. 8' - 3"ft

MOUNTING BRACKET

REMOVE THIS SCREW TO
RELEASE MOUNTING PLATE.
SECOND SCREW FOUND
ON OTHER SIDE.
Safety and Installation Instructions
ATTENTION : L'INSTALLATION ET L'ENTRETIEN DE CE PRODUIT DOIVENT ETRE
EFFECTUÉS PAR UN ÉLECTRICIEN OU UN MEMBRE DU PERSONNEL QUALIFIÉ.
PRODUCT MUST BE LEVELED IN THIS DIRECTION
Floor
Signify North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873
Telephone: 855-486-2216
UWL120-UNV-1/1-EB
90029520I84598322
Signify Canada Ltd.
281 Hillmount Road
Markham, ON, Canada L6C 2S3
Telephone: 800-668-9008
Rev. 2 - 5/21