Metal Works CAT 210 Mode D'emploi page 11

CAT210 - NLFRENES - v2.0 - 16072013
EN
5. Assemble the filter.
7. Assemble the
blast gun.
8. After you complete the assembly of
the blast cabinet, you shall assemble the
transparent top lid (01), lock up the movable
leaf above the rear panel (03).
6. Push the fluorescent lamp (26) into lamp clamp (6), then put the
electric cord outside the hole through 4L. Use screw nut (26-1) which
is enclosed on the cord to secure, then combine with the circuit inside
the wire connection box (27) and up tight at left panel (4L).
9. Upon locking up the movable leaf, put
the transparent top lid under the movable
leaf. To lock up the handle, first put the item
(22) though the holes on the movable leaf,
press hard to lock onto the top lid.
10. Open up the top lid and connect the
positioning chain. Please connect the two
ends of the chain with the screw and screw
nut as illustrated. This will prevent the top
lid from falling off (this can damage the top
lid).
®
11