Frigidaire FFRH18L2RR Instructions D'installation page 5

6
Extend Window Filler Panels and attach to top angle rail:
1. Carefully raise window to expose filler panel locking screws on top angle rail. Loosen screws so filler panels slide
easily.
2. Extend panels to fill window opening completely. Tighten locking screws on top (FIG. 16).
3. Close window behind top angle rail.
4.
angle rail into the window frame as shown (FIG. 17).
FIG.16
LOCKING SCREWS
7
Attach Window Filler Panels to Window Frame
1. Extend the window filler panels out against the window frame.
2. Use a 1/8" drill bit to drill a starter hole through the hole in the
top leg of each window filler panel and into the window sash
(Fig. 18A and Fig. 18B). Connect with one 1/2" long hex head
screw.
8
Install Window Sash Seal and Safety Lock
1. Trim window sash seal to fit window width. Insert it into
space between upper and lower sashes as shown (FIG. 19).
2. Attach right angle safety lock to top window sash as
shown (FIG.20).
3. If necessary, trim weather seals to needed length, peel
off protective backing, and use to plug any gaps. See Fig. 18B.
FIG.19
9
Install Air Conditioner into Cabinet and Install Front Panel to Unit
1. Lift air conditioner and carefully slide into cabinet.
2. CAUTION: Do not push on controls OR finned coils.
3. Be sure air conditioner is firmly seated towards rear of cabinet.
4. Reconnect electronics plug if present. Position vent control lever so that it will thread into its channel in the front
panel (see FIG.21). Hook front panel top tabs into slots on cabinet top, and rotate front panel down so that side tabs
snap into place on cabinet. Insert 4 previously removed screws through front panel and into air conditioner.
5. Insert air conditioner filter. Reinstall the front grille by hooking bottom tabs into slots on Front Panel bottom, then
rotating grille up to snap into place.
Installation Instructions
and Washer
FIG.20
WINDOW
SASH SEAL
HEX-HEAD locking screw through the hole in the middle of top
FIG. 17
Locking Screw
C
Window Sash
A. long hex head screw
B. left-hand Window Filler
Panel Top Leg
C. Window channel
SAFETY LOCK
hex-head
screws
FIG. 18A
B
A
A. long hex head screw
FIG. 21
HEX-HEAD
SCREW
FIG. 18B
weather seals
A
Vent control
correct location
5