Mounting On The Wall - LaserLiner LaserCube Mode D'emploi

2
On-floor applications
Place the device on the floor and switch on.
3
Wall applications
Mount the device on the wall for horizontal and vertical levelling.
Then align the device with the vials.
4

Mounting on the wall

1. Place device on the wall.
2. Push the special pins through the appropriate holes.
Technical data
Accuracy
Laser wavelength
Laser class /
line laser output power
Power supply
Operating time
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. batteries)
Subject to technical changes without notice. 09.15
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
A
!
B
± 1 mm / m
635 nm
2 / < 1 mW
3 x alkaline batteries
(LR 44 / AG13 / V13GA)
4 hours (alkaline batteries)
0°C ... +40 °C
-10°C ... +70 °C
38 x 38 x 38 mm
36 g
LaserCube
The vials are only adjusted
for the four A bearing
surfaces (see image). When
placed on the B surfaces,
the device cannot be used
as a spirit level.
05
GB