TIPTEL 410 Guide D'installation page 19

Notes for network admins
The telephone system comprises a DHCP client and a DHCP server. When booting
the telephone system tries to obtain an IP address from a DHCP server in the net-
work. If this is successful the telephone system's web configuration can be accessed
under the assigned IP address. In case there is no DHCP server available or the tele-
phone system could not obtain an IP address due to other reasons the following fac-
tory default settings will be active:
IP address of the:
telephone system
Subnet mask:
User name/password:
DHCP server:
Address range:
To adapt these data to your network please connect a caller ID telephone to the tele-
phone system. Please dial for:
-Display IP address
(Display is made via Displayinfo and call back)
- Write IP address
(you will hear a positive prompt "Tataa")
-Display subnet mask
(Display is made via Displayinfo and call back)
- Write subnet mask
(you will hear a positive prompt "Tataa")
Factory default PIN: "0000".
If you modify the IP address via key code at your telephone, the telephone system
can be accessed under that IP address after a short while. The DHCP client then was
deactivated and the chosen IP address was saved as static IP address.
The DHCP server is still active but was adjusted to the address range of the chosen
IP address. In case you do not wish to use the DHCP server or such a server is al-
ready active in your network, you can deactivate the telephone system's DHCP server
in the web configuration under "Network - Settings - DHCP Server".
Quick Installation Guide
192.168.34.100
255.255.255.0
admin/admin
active
192.168.34.10 to 192.168.34.29




19
and hang up
PIN xxx xxx xxx
  
and hang up
PIN xxx xxx xxx
  
xxx
 
xxx
 