Weekly Cleaning; Operating - Honeywell HUL535 Série Instructions

FILLING/REFILLING
NOTE: Water Tank should be carried using two hands. One hand using carrying handle located
on tank top and other hand supporting the base of the tank.
Manufacturer will not accept responsibility for property damage caused by water spillage.
Step 1 Step 2
1. Remove Tank and turn upside down.
2. Turn Tank Cap in the direction of the open lock symbol to remove cap.
3. Fill Tank with cool water. Do not fill with warm or hot water.
4. Securely replace Tank Cap, aligning arrow to lock symbol. Be sure that black Cap Seal
is securely in place.
5. Place Tank back on base.
CAUTION: Use care when handling Water Tank to avoid unnecessary impact. Banging
or dropping the Water Tank could result in damage to the tank that will cause leaking.

OPERATING

Step 2
Step 1
1. Power: With the Power Knob in the off position, plug humidifier into a polarized 120V outlet.
CAUTION: To avoid electric shock do not plug humidifier into outlet with wet hands.
2. Output: Turn the Power Knob to highest setting.
3. Direct mist output away from walls, furniture and bedding.
4. Humidity Level: When a comfortable humidity level is reached turn Power Knob to a lower
setting. A comfortable humidity level is between 40-60%.
To monitor your humidity level use a humidity monitor such as the Vicks V70 or V70-CAN
model or the Honeywell HHM10 model or H10C model.
If you notice condensation on the walls, windows or around unit, your humidity level is too
high. Turn humidifier off.
CAUTION: Before moving humidifier, turn off, unplug and empty the humidifier.
4
Step 3 Step 4 Step 5
Step 3 Step 4

WEEKLY CLEANING

To properly clean your humidifier we recommend the separate processes of Scale Removal
and Disinfecting shown below. These two processes MUST BE performed separately.
All maintenance should be done in the kitchen or bathroom on a water resistant surface near
a faucet. Do not wash any components of this humidifier in the dishwasher.
Instructions for Scale Removal
Step 1
1. Turn off and unplug the humidifier.
2. Remove Water Tank from Base. Remove Mist Outlet from top of Water Tank and set aside.
Remove Tank Cap, taking care that black rubber Cap Seal does not come off. Empty water
from Water Tank and Base.
3. If accessory is installed, remove accessory and set aside. Do not clean accessory. This will
damage the accessory.
4. Add 2 cups of undiluted distilled white vinegar to Water Tank. Replace Tank Cap and swish
vinegar solution around in Tank. Place Tank on Base. Vinegar solution will drain into Water
Reservoir and loosen mineral buildup (scale) on Nebulizer and Float as they soak in the
solution. It will also loosen scale on bottom of Water Tank.
Step 5
4
5. Soak for 15-20 minutes.
6. After soaking, unlock Tank Cap and pour solution out in sink. Use solution from Water
Reservoir to wipe the underside of the Mist Outlet with a clean cloth.
7. Pour solution from Water Reservoir out in sink. Wipe Nebulizer and Float with soft cloth
to remove loosened mineral deposits.
8. Rinse Water Reservoir and Water Tank until smell of vinegar (for Scale Removal process)
or bleach solution (for Disinfecting process) is gone. Make sure water does not enter the
fan opening (vented opening in back of base) or Power Knob.
CAUTION: Do not submerge base in water. Doing so will damage the humidifier and void
the warranty.
Step 2 Step 3
Step 6 Step 7
Step 4
2 cups
Step 8
5