Evolution 062-0001 Instructions D'origine page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fig. 8
Fig. 9
Fig. 10
Fig. 11
4. Positioning the Sanding Arm
For operator convenience and operational efficiency the
position of the sanding arm relative to the machines handle
can be adjusted through approximately 120˚. (Fig.8)
WARNING: Always ensure that the machine is disconnected
from its power source before repositioning the sanding arm.
To reposition the Sanding Arm:
• Release the arm by pushing the sanding arm locking lever
forwards (towards the sanding arm).
• Position the sanding arm at the required angle.
• Pull back the locking lever to lock the arm in the
required position.
5. ON/OFF Trigger switch (Fig. 9)
The 'ON/OFF' trigger switch is located in the machines handle.
• Depress the trigger to start.
• Release the trigger to stop.
Note: For operator convenience the ON/OFF trigger switch
can be locked in the 'ON' position by depressing the trigger
locking button. (Fig. 10) To switch off from the 'locked'
position, gently press the trigger switch and then release.
WARNING: Always ensure that the machine is switched 'off'
and the belt is stationary before putting the machine down
onto a workbench or similar.
6. Speed Control
The rotary speed control selector is located on the top of the
machines handle. (Fig. 11) Turn the selector to set the speed
required (infinitely variable between 300 – 1600 m/min)
7. Hand Grip Area
The top surface of the machines handle is coated with a soft
grip area for enhanced operator control and comfort.
8. Grit selection
Sanding belts are available in a variety of grades depending upon
the coarseness (particle size) of the grit embedded in the cloth.
10
www.evolutionpowertools.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

062-0002062-0003062-0004

Table des Matières