Evolution 062-0001 Instructions D'origine page 9

www.evolutionpowertools.com
2. Replacing/changing a Sanding Belt
WARNING: Always ensure that the machine is disconnected
from its power source before attempting to change or replace
the sanding belt.
• Pull the belt release lever (located just above the belt
tracking control knob) upwards to release the tension on
the belt. (Fig. 4)
• Slide out the belt to be replaced.
• Refit the required belt over the rear and front rollers. (Fig. 5)
Note: Always ensure that the direction of rotation arrows
found on the inside of the belt match the direction of rotation
arrow found on the body of the machine. (Fig. 6)
• Return the belt release lever to its original position.
3. Centring the Sanding Belt
WARNING: Wear eye protection when attempting to centre
the sanding belt.
• Hold the machine so that you have a clear view of the belt.
• Start the motor and observe the position the belt adopts
after a few seconds of running at operational speed.
If the sanding belt is not running centrally along the length of
the sanding arm, turn the belt tracking control knob a little in
either direction until correct tracking is achieved. (Fig. 7)
Only turn the tracking control knob by a few degrees at a time
before observing the position of the belt along the sanding arm.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
9
EN