Ariston Eco Manuel page 28

GB
SLEEP/INTELLIGENT EYE function
Keep this button pressed for at least 2 seconds to activate the SLEEP function.
By keeping it pressed for more than 2 seconds, the INTELLIGENT EYE function is acti-
vated.
• The Sleep function allows the unit to automatically increase (cooling) or decrease
(heating) the temperature by 1°C an hour for the fi rst two hours, to then remain con-
stant for the next 5 hours and fi nally shut down. In this way it is possible to maintain
an optimal temperature in terms of both comfort and energy saving.
NOTE: The SLEEP function is only available in cooling, heating and AUTO mode.
• The Intelligent Eye function allows the air conditioning unit to enter the stand-by
mode if it does not detect any activity for more than 30 minutes. The unit reactivates
automatically with the previous settings as soon as the presence of people is identi-
fi ed.
The air conditioning unit deactivates this function each time it is turned off or the
SLEEP, SELF CLEAN or TIMER button is pressed.
LED/FOLLOWME function
Keep this button pressed for at least 2 seconds to activate the LED function which turns
off the display of the internal unit.
By keeping it pressed for more than 2 seconds, the FOLLOW ME function is activated.
• By activating the Follow Me function, the remote control system detects the actual
temperature in the room where it is located and sends this signal to the air condition-
ing unit every 3 minutes, until the FOLLOW ME button is not pressed again.
• The Follow Me function is not available in DRY and FAN mode.
• By switching to a diff erent operating mode or turning off the unit, the Follow Me func-
tion is automatically deactivated.
TURBO/SELF CLEAN function
Keep this button pressed for at least 2 seconds to activate the TURBO function. By keep-
ing it pressed for more than 2 seconds, the self clean function is activated.
• The Turbo function allows the unit to reach the preset temperature in the shortest time
possible. When the unit is in cooling mode, by pressing this button a strong cold air
fl ow is activated with the fan at maximum speed. In units fi tted with PTC, when this
button is pressed in heating mode, the PTC is powered and the heating action ac-
celerates.
• In SELF CLEAN mode, the air conditioning unit automatically cleans and dries the
evaporator, keeping it in optimal conditions for subsequent operation. (through a fan,
heating, low speed fan cycle). The Self Clean function is only activated in cooling or
dry mode.
28 /