ton pressed for at least 2 seconds again.
7. RESET button
By pressing the recessed RESET button, all the current settings are cancelled and
replaced by the initial settings.
8. + button
Press this button to raise the set temperature or to increase the time value during the
timer programming.
9. - button
Press this button to lower the set temperature or to decrease the time value during
the timer programming.
10. SILENCE/ECO (in models equipped with this function)
Used to enable and disable the silence function. Press and hold for 2 seconds to
enable the ECO function (in models equipped with this function); to disable it, simply
press and hold the button again for longer than 2 seconds.
11. FAN SPEED button
Use this button to select the fan speed in the four options available in sequence:
AUTO > LOW > MED > HIGH
12. TIMER button
It is used to set the automatic start up/shut down delay via the timer. Each time the
+/- button is pressed, the delay setting increases/decreases by 30 minutes. When
the set delay reaches the value of 10:00, as indicated on the display, each time the
+/- button is pressed, the automatic shut down delay setting increases/decreases by
60 minutes. To cancel the programming via the timer, just set the delay to 0:00.
13. MEMORY button
It is used to save the current settings or restore the previous settings.
14. LED/FOLLOW ME button
It deactivates and activates the LED function. By keeping it pressed for more than 2
seconds, the FOLLOW ME function is activated. To deactivate it, just keep the button
pressed for more than 2 seconds again.
15. LOCK button
By pressing the recessed LOCK button, all the current settings are locked and the
remote control system no longer responds to any command, except the LOCK but-
ton being pressed. Press it again to cancel the LOCK mode.
NOTE:
All the function described above are carried out by the internal unit. If the latter does not
have a certain feature, by pressing the respective button on the remote control system
no operation is activated.
GB
\ 21