Troubleshooting - PURE Highway 600 Manuel D'utilisation

Troubleshooting

Problem Possible cause
The wireless controller The antenna isn't connected
displays 'ANTENNA to the power supply, or the
CONNECTING' or controller isn't paired
'CHECK POWER correctly with the antenna.
TO ANTENNA'.
The status light on the Your Highway is in update
antenna is constantly lit. mode.
The status light on the The controller has lost
antenna is flashing. connection with the antenna.
Solution
Remove the power adapter from the 12V socket, then insert it. If the antenna has power, the
antenna's status light lights up for 5 seconds and the controller connects to the antenna within
30 seconds. Note: If you can't access the power adapter, perform a power reset*.
If this doesn't solve the problem, pair the controller with the antenna:
1. Use a paperclip to press the reset button on the antenna. The status light on the antenna
flashes slowly.
2.
Place the controller within 50cm of the antenna, then press and hold , and
together.
If the controller does not connect to the antenna within 30 seconds, repeat steps 1 and 2.
If you are updating the software, finish the update. If not, remove the power adapter from the
12V socket, then insert it. If the antenna has power, the status light on the antenna lights up for
5 seconds and the controller connects to the antenna within 30 seconds. Note: If you can't
access the power adapter, perform a power reset*.
To pair the controller with the antenna:
1. Use a paperclip to press the reset button on the antenna. The status light on the antenna
flashes slowly.
2. Place the controller within 50cm of the antenna, then press and hold , and
together.
If the controller does not connect to the antenna within 30 seconds, repeat steps 1 and 2.
21