Operations From A Computer; Controlling The Display From A Computer - Sony BKM-FW31 Mode D'emploi

Operations from a
Computer
Controlling the Display from a
Computer
You can perform various adjustments and
settings of the Display on a computer's
display. Check that this device is firmly
installed in the Display and that this device,
the personal computer, and the router or
hubs are connected via LAN cables. Then
turn on the display, the computer, and the
router or hubs. Four control windows are
available; Information, Configuration,
Control, and Setup, each with distinct
functions.
For details on the buttons, see the Operating
Instructions of the FWD series as well.
1
Start the computer's browser (Internet
Explorer 6.0 or later).
2
Type "http://xxx.xxx.xxx.xxx (for the
IP address of this device)" and press
the ENTER key of the keyboard. You
can confirm the IP address of this
device using the information menu of
the Display unit.
3
Click the function tab to select the
window you want.
10
GB

Operations from a Computer

Information window
This window displays information about
the Display unit, such as the Model name,
Serial No., and the current operating status
of the Display unit, including the presence
of power and an input signal.
This window only displays information.
You cannot change settings using this
window.
Configuration window
Timer
Sets the timer.
After setting the timer, click Apply.
Screen Saver
Sets the screen saver.
After setting the desired screen saver, click
Apply.
Picture and Picture
Sets the Picture and Picture mode.
After setting the desired mode, click Apply.
NOTE
Refer to the Operating Instructions for the
FWD series for details on each function as
well.
Depending on the Display model, some
functions are not supported.
Control window
POWER (power switch)
Turns the power of the Display unit on or
off.
INPUT (input selector)
Switches the input signal.
PICTURE MODE (picture mode)
Switches the picture mode.
ASPECT (aspect)
Switches the width of the screen display.