Make Power Supply Cord Connection - Whirlpool WDF320PADB Instructions D'installation

Using 2 or more people, grasp sides of dishwasher door frame
and place dishwasher on its back.
Using a flat-blade screwdriver, turn the plastic fasteners ¹⁄₄ turn
counterclockwise to unlock them. Remove panel. Do not remove
tech sheet from access panel.
Using a ¹⁄₄" hex-head socket, nut driver or Torx
remove terminal box cover. Retain for later use.
12
Install a UL Listed/CSA Approved strain relief. Make sure screw
heads are facing to the left when tightening conduit nut. Strain
relief is provided with the power supply cord kit.
NOTE: If using Option B, proceed to "Determine Cabinet
Opening," to continue with the installation of your dishwasher.

Make Power Supply Cord Connection

Option A, Power Supply Cord:
® T20 ® screwdriver,
Route cord so that it does not touch dishwasher motor to lower
part of dishwasher tub. Pull cord through strain relief in terminal
box.