BH FITNESS G-238 Mode D'emploi page 20

tighten securely.
Lower the bottom trim section for the
main post (100) down over the boss
section of the main body (5), Fig 6C.
IMPORTANT:
retighten these screws after one
month of using the machine.
Mod. G-239.-
Take the main post (100) and remove
the screws (29) the washers (7) and
spring washers (8) from the bottom of
the post (100). Fig.5.
Next, bring the main post (100) up to
boss (D) on the main body (5), Fig. 5,
connect the terminals (66) and (34),
Fig. 5B.
Slip the main post (100) over the boss
(D) on the main body (5) in the
direction of the arrow, figure 5, making
sure not to snag any of the cables.
Refit the screws (29), the washers (7)
and the spring washers (8) that you
removed previously,
tighten securely.
Lower the bottom trim section for the
main post (100) down over the boss
section of the main body (5), Fig 6C.
ATTENTION: It is advisable to
retighten these screws after one
month of using the machine.
4. FITTING THE FOOT BARS
Loosen off screw (11) along with the
spacer (59), the washer (33) and the nut
(32), using the Allen key (B) and the
combination spanner (C) to help you,
Fig. (6).
Take the left foot (82) and insert the
spacer (59) in the direction of the arrow,
Fig. (6A) leaving it centred.
Next, position it on the "U" at the bottom
of the left focus bar (10), Fig. (6B).
Insert screw (11), as shown in Fig. 6B,
then fit the flat washer (33) and the
It is advisable
Fig. 5,
self locking nut (32), and tighten
securely.
Take the right foot bar (83) and go
through the same assembly procedure
to
as with the left.
Then fit the trim covers (12 & 31),
using screws (13) to secure them, Fig.
6D.
5. FITTING THE ELECTRONIC
MONITOR
ATTACHING THE MONITOR
Release screws (15), Fig 7, at the
back of the monitor (14).
Mod. G-238
Insert the tip of the cable (75) inside
the monitor support tube (17), Fig. 7A.
Then connect terminals (40 & 34).
The handgrip terminals (41a with 41)
and (42a with 42), Fig. (7B).
Next, slide the front of the monitor
onto the plate on top of the main post
(17) in the direction of the arrow, Fig.
and
7, push the cables down into the main
post making sure not the pinch any of
the cables. Replace the screws (15)
removed previously.
Mod.G-239.-
Release screws (15), Fig 7, at the
back of the monitor (14).
Then connect terminals (40 & 34).
The handgrip terminals (41a with 41)
and (42a with 42), Fig. (7C).
Next, slide the front of the monitor
onto the plate on top of the main post
(17) in the direction of the arrow, Fig.
7, push the cables down into the main
post making sure not the pinch any of
the cables. Replace the screws (15)
removed previously.
Then fit the trim covers (12 & 31),
using screws (13) to secure them, Fig.
6D.
20