Cleaning And Maintenance; Storage - SilverCrest SSSES 1.5 B2 Mode D'emploi

Cleaning and maintenance

CAUTION! MATERIAL DAMAGE
► Do not use caustic, abrasive or solvent-based cleaning
materials. They can damage the surfaces of the appliance.
♦ Switch off the appliance by pressing the On/Off button
for approx. 3 seconds. The red LED
3 seconds.
♦ Wipe the appliance with a damp cloth. If required, use a mild
washing-up liquid on the cloth.
♦ If the sensor
♦ If you do not intend to use the appliance for a longer period
of time, clean the soap tank
1. Remove the soap tank
2. Wash out the soap tank
the remains of the soap inside.
3. Reattach the soap tank
small amount of clean water, to the main appliance
and switch on the appliance.
4. Activate the soap dispenser
the soap dispenser
the main appliance
5. Remove the soap tank
Empty the soap tank completely and leave to stand for a
short while with the soap tank latch
to allow it to dry out in the open air.

Storage

CAUTION! MATERIAL DAMAGE
► Do not turn the appliance upside down when drying! If you
do, water may enter the appliance and damage it!
♦ Switch off the appliance by pressing the On/Off button
approx. 3 seconds.
♦ Always clean the appliance thoroughly before storing.
♦ Remove the batteries from the main appliance
♦ Store the appliance in a clean, dry location away from direct
sunlight.
SSSES 1.5 B2
6
is dirty, clean it carefully with a damp cloth.
3
for approx. 3 seconds. The red LED
2
8
in the following manner:
8
from the main appliance
8
with clean water to dispose
8
, which has been filled with a
5
a few times, so that both
5
and the connecting tubes inside
7
are rinsed out.
8
from the main appliance
lights up for approx.
9
remaining open
2
lights up for
7
.
GB │ IE │
3
7
.
7
7
.
9 ■