Setting The Date And Time - Olympus CAMEDIA C-770 Ultra Zoom Manuel De Base

basic_e_d4209_7.fm Page 15 Tuesday, February 3, 2004 3:02 PM
SETTING THE DATE AND TIME X
1
Slide the power switch to K to turn the camera on.
2
Press e.
• The top menu is displayed.
3
Press d on the arrow pad to select MODE MENU.
• When the mode dial is set to h, press
4
Press ac to select the SETUP tab, then press d.
5
Press ac to select X, then press d.
• The green frame moves to the selected item.
6
Press ac to select one of the following date formats:
Y-M-D (Year/Month/Day), M-D-Y (Month/Day/Year), D-M-Y
(Day/Month/Year). Then press d.
• Move to the year setting.
• The following steps show the procedure used when the date and time
settings are set to Y-M-D.
7
Press ac to set the year, then press d to move to the
month setting.
• To move back to the previous setting, press b.
• The first two digits of the year are fixed.
8
Repeat this procedure until the date and time are
completely set.
• The time is displayed in the 24-hour format.
Consequently, 2 p.m. is displayed as 14:00.
9
Press e.
• For a more accurate setting, press e when the time signal hits 00
seconds.
10
To turn the camera off, slide the power switch to OFF.
• The date and time settings will be returned to the factory default
settings if the camera is left without the battery for approximately
one day. The settings will be canceled more quickly if the battery
Note
was only loaded in the camera for a short time before being
removed. Before taking important pictures, check that the date and
time settings are correct.
c
and go to Step 6.
En
En 15