ShelterLogic ShelterCoat 13'W x 10'H Peak Mode D'emploi page 6

6. INSTALL TOP CROSS RAIL
A. Connect the first cross rail (#10133) to the front end rib and secure it with bolt (#10115) as shown in Fig. 7A.
HAND-TIGHTEN this bolt.
B. Connect the middle cross rails (#02030) to the first cross rail. Lay them over the top of the middle ribs and
connect using round head bolt (#00669). Fig. 7B.
C. Connect rail #10134 to complete the top cross rail. Connect to end rib with bolt #10115. Fig. 7A.
Top Cross Rail at End Rib
10115
10121
01010
Fig.7A
7. SQUARING UP THE FRAME
A. Be sure that frame in its final location, which needs
to be as flat and level as possible.
B. Measure across opposite corners.
These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame
measures 13' 6" in width.
8. INSTALL AUGER ANCHORS
A. Anchors must be placed inside shelter at the corner
legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the
eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
B. Thread cable provided through the eyelet of the Anchor
as indicated in figure 9. Secure the cable with the
clamps provided.
If the ground is too hard, dig a hole with a shovel or post
hole tool. Optional: Fill with cement.
If you are anchoring in gravel, clay, or asphalt,
ShelterLogic recommends the Easy Hook
®
Anchors. Use one at each leg for a stronger, more
secure installation.
02030
10133
™ Drive
Page 6
10134
13' 6"
Fig.9
Middle Rib
05_GP-AA-XXXXXXA-013XXX10_E1
Top Cross Rail OVER Middle Ribs
00669
Fig.7B
01010
Fig.8
13' 6"
End Rib