Technical Specification; Depth Of Cut - CMT ORANGE TOOLS CMT-ENLOCK1 Manuel D'utilisation

TECHNICAL SPECIFICATION

The CMT-ENLOCK1 is designed for the machining of a single dovetail slot in timber required for the
use of enlock keys CMT-ENLOCK10 and CMT-ENLOCK15.
Dovetail router bits:
Guide bearing:
Timber thickness range:
Timber width range:
SECURING THE SYSTEM TO A WORKBENCH
The CMT-ENLOCK1 is designed to be screwed to the workbench through holes in the support feet
(Fig. 1, pos. 15). Ensure that the unit is stable and securely fixed in place before use.

DEPTH OF CUT

Ideally, the key groove should be cut to a depth of 13mm for CMT-ENLOCK15 key and 8.3mm for
CMT-ENLOCK10 keys (Fig. 2). This might vary slightly depending on timber type and may require
some experimentation.
Fig. 2
4
for keys CMT-ENLOCK10
D=9.5 I=9.5 14°
router bit CMT 718.098.11B - 818.098.11B
for keys CMT-ENLOCK15
D=12.7 I=12.7 14°
router bit CMT 718.127.11B - 818.128.11B
12.7mm
min 25mm, max 45mm with CMT-ENLOCK1
min 14mm, max 20mm with CMT-ENLOCK10
min 19mm, max 35mm with CMT-ENLOCK15
30mm to 75mm
www.cmtutensili.com