Poresta Systems BF 70 Instructions De Montage page 6

Einbauanleitung
Mounting instruction
Montagehandleiding
Instructions de montage
Istruzioni di montaggio
Use:
- The shower system Poresta
by the installer laterally and opposite of the drain in consideration
of the size, the installation height and the geometry of the shower
system.
- The kind of utilization of the shower space (splash protection, move-
ment area, etc.) is to be considered.
- For the installation of the shower system a level, clean, solid
surface free of vibrations and suited for fastening with Poresta
Flex must be available.
- The shower system is generally accessible for wheel chairs when
using tiles of a minimum size of 100 x 100 mm. If glass fabric is
worked into the tile adhesive bed, also tiles of a minimum size of
50 x 50 mm may be used.
- Suitable only for use indoor.
The relevant processing guidelines of all trades involved must
be observed.
For the installation (screed base height >75 mm), either
1
substructure elements (not included in the scope of supply) or
a cast plaster floor base are being used.
Apply Poresta Profi Flex to both sides. If add-on boards are
®
2
used, apply Poresta
BF 70 and to the add-on boards.
3
Edge insulation strips shall be provided by the owner.
Remove sealing ring from the plug-in connection and insert
4
into sleeve.
After installation of the outlet fitting, a leak test is to be
5
performed.
Before closing the drain duct apply a suitable thermal and
6
acoustic protective sheathing to the drain line.
Close the drain duct with Poresta
7
Profi Flex should not be too moist after mixing. The process-
ing instructions of the manufacturer shall be observed.
The processing guidelines of the Poresta
8
observed.
® BF 70 may be variably cut to size
® Profi Flex also to the front sides of the
Profi Flex. The Poresta
®
KMK are to be
®
Example for installation with Poresta
Mounting height/finished floor level
Poresta BF 70
®
2 layers of Poresta
Poresta UBE substrate element
®
The shower system Poresta
materials of construction material class B2 according to DIN 4102-1 (normally inflam-
mable) of class E according to DIN EN 1350-1 in installed condition.
® Profi
®
UBE substrate element:
®
Profi Flex
®
BF 70 meets the requirements relating to the construction
®
Poresta BF 70
®
100 mm
-70 mm
-10 mm
= 20 mm