Dri-Eaz LGR 7000XLi Instructions D'emploi page 5

Reinstalling the Heat Block and Top Cover
NOTICE: Be sure housing bolts are properly threaded before tightening. Do not overtighten. Do not use a
power tool!
Reinstall the heat exchange block. Be sure to position it
in the original orientation.
Carefully reseat the heat exchange block. Make sure that
the block is flush against the base and vertical condenser
(hot) coil,
Make sure the top of the block is flush with the top of the
condenser coil.
Replace the sensor chip assembly in to the heat
exchange block.
NOTICE! The sensor chip assembly is fragile. Handle
with care at all times. To avoid potentially damaging the
sensor with a static electricity discharge, do not touch
the sensor circuitry and do not place any tape or other
material in contact with the sensor circuitry.
Slide the top cover straight down into place. Make sure
the foam rubber seal strips are in place and are not kinked
or folded.
Replace the front cover. Insert and tighten the front cover 3 ∕ in. bolts by hand. After they are hand tight, install
8
and tighten the two back cover bolts.
NOTICE: Be sure housing bolts are properly threaded before tightening. Do not overtighten. Do not use a
power tool!
The unit is now ready for use.
16-09A F412-115V 5 Dri-Eaz Products, Inc.