Medion MD 16904 Traduction De La Notice Originale page 91

 Carefully lift off the housing cover without dropping
the cutting tool.
 Set the tool that is not required to one side.
 Lubricate the tool and the eccentric drive.
 Smear some lubricant on the cutter drive and on the
cutting tool.
 Fit the new tool with the eccentric mounting facing
towards the appliance so that the base plate (C) of the
tool fits into the slots on the housing. Ensure that the
pins of the eccentric shaft (B) and the drive shaft (A) fit
into the holes on the appliance.
 If necessary move the pin on the eccentric mounting
(D) upwards so that the cutting tool can be fitted into
position.
 Hold the cutting tool in this position and replace the
cover on the appliance.
 Push the housing cover against the direction of the
arrow until it clicks into place.
92 of 104
A B
C D