Danger!
To rule out danger, this work must be left strictly to a specialist electri-
cian or Customer Service.
6. Operation
You can put the equipment into operation after you have thoroughly
read the installation and operating instructions. Pay attention to the
following points:
•
Make sure that the equipment is set up securely.
•
Check that the discharge line is fitted correctly.
•
Make sure that the electrical connection is 230 V ~ 50 Hz.
•
Check that the electrical socket-outlet is in good working order.
•
Make sure that no moisture or water can ever reach the power
connection.
•
Make sure that the equipment does not run dry.
•
To switch off the equipment, pull the power plug out of the socket
outlet.
Setting the On/Off switching point:
The ON/OFF switching point of the fl oating switch can be adjusted by
shifting the fl oating switch in the fl oating switch notched holder (Fig.
2/Item 5).
•
The floating switch must be fitted so that the switching point
height: ON and the switch point height: OFF can be reached ea-
sily and with little force. Check this by placing the equipment in
a container filled with water and carefully raising and lowering
the floating switch with your hand. You can then see whether the
equipment switches on and off.
•
Make sure that the distance between the floating switch head and
the cable holder is not too smaller than 10 cm. If the distance is
too small, there is no guarantee that the equipment will work cor-
rectly.
Anl_PE_KW_300_SPK7.indb 141
Anl_PE_KW_300_SPK7.indb 141
- 141 -
GB
08.10.15 14:19
08.10.15 14:19